1978-1983 Cutlass Transmission Crossmember T-56 6 Speed RCG-4L80K

These high performance G Force transmission crossmembers give you the room to run a true dual-exhaust system with a T-56 6 Speed. These transmission crossmembers have a double-hump design, which gives you plenty of ground clearance! These crossmembers are a direct bolt-on. They're made from boxed tubing (1/8 in. thick) to handle the frame-twisting power of your high performance small block, big block, or LS1, LS2, LS3, or LSX engine.

Manufacturer Part Number : RCG-4L80K

Part Notes:

In some installations, it is necessary to remove the catalytic converter heat shield from the passenger side floor pan. This generation of vehicle is prone to body bushing compression, even with some southern vehicles. If the floor pan is too close to allow installation, it may be necessary to replace the body bushings. Some customers have reported that with slight interference instances, they have been able to gently lift the floor pan with the assist of a floor jack and a wood cushion, thus providing the required clearance for installation. The crossmember is installed so that the exhaust clearance humps are closed on the top and open on the bottom. The primary frame change on this generation of vehicles is beginning with 1984 models and the implementation of the 2004r transmission which required positioning the crossmember further to the rear of the vehicle. This is evidenced by 2 sets of frame holes for the crossmember on the driver side of the vehicle. G force has developed the frame extension to duplicate this longer frame on the early generation vehicles. Rcg-400k is pre-packaged with the frame extension. Note: while this change was platform wide beginning in 1984, some 1983 Hurst olds are known to have the 2004r transmission and thus the longer frame rail.